Page 1 of 1
Steps after audiogram entry
Posted: Wed Jul 07, 2021 8:00 pm
by dpoznan
Is there an example of the step by step process of going from audiogram entry to
correction stored and applied to the hearing aids?
I want to be able to do a direct comparison with this portable B & C research hearing aid and my new ReSound hearing aids.
Dan..
Re: Steps after audiogram entry
Posted: Thu Jul 08, 2021 9:48 am
by tobiasherzke
There is a fitting GUI manual at
http://www.openmha.org/ documentation.
Re: Steps after audiogram entry
Posted: Mon Jul 12, 2021 8:07 pm
by dpoznan
I have reviewed the GUI manual and have gone through the steps of entering my audiogram, and running the FirstFits.
However, I have no idea from the document how one causes the hearing aids to utilize a particular fitting.
How does one switch between different fittings. How does on adjust a fitting?
(I may not be using the proper terminology...I'm new to this.)
Any suggestions/help would be appreciated
Re: Steps after audiogram entry
Posted: Mon Jul 19, 2021 6:20 pm
by tobiasherzke
dpoznan wrote: ↑Mon Jul 12, 2021 8:07 pm
How does one switch between different fittings.
By clicking on the respective lines in the "Presets" box.
How does on adjust a fitting?
By changing the frequency-specific gains with the fine-tuning controls at the bottom of the GUI.
Hope this helps!
Re: Steps after audiogram entry
Posted: Sat Jul 24, 2021 6:00 pm
by dpoznan
I have a NAL_NL2 fit from my audiologist. I would like to enter it in the presets. I cannot find where they are stored and the format of the file. How do I create my own preset?
Thanks,
Dan..