Control Dynamic Compression using Octave/Matlab GUI

Post Reply
steffendasenbrock
Site Admin
Posts: 12
Joined: Thu May 02, 2019 1:08 pm

Control Dynamic Compression using Octave/Matlab GUI

Post by steffendasenbrock » Tue Sep 17, 2019 9:04 am

This post offers an introduction into the dynamic compression using a Octave/Matlab GUI. This is covered in section 5 of the Getting Started Document (displayed below) which you can also download under the following link:

http://www.openmha.org/docs/openMHA_starting_guide.pdf

If you have questions about the dynamic compression feel free to post them here. For other topics regarding the Getting Started document find the corresponding post to that specific section.


Post Reply